The maximum particle size of a limestone sample received from a cone crusher was 2.5 cm. It was required to further crush it down to 0.5 cm in a roll crusher with smooth rolls. The friction coefficient between steel and particles was 0.25, if the rolls were set at 6.3 mm and both revolved to crush, estimate the diameter of the rolls.
The reduction ratio of the crusher size is simply calculated as the ratio of the particle size of the raw material and particle size of the crushing. Step1: When the maximum size of the particle is being considered and along with that the broken material after the product and before the size of the particle to be a maximum particle, the ratio ...
The hammer crusher is a crusher that directly crushes materials with a maximum particle size of 600 1800 mm to 25 or less. Hammer crusher is a kind of equipment for crushing materials in the form of impact. It is divided into single rotor and double rotor.This hammer mill crusher can save you cost and time because of shaping materials one time.
The difference between the cumulative percentages at the 3.5 and 1.5 points on the curve gives us the amount, of such product to be expected from the output of the primary crusher This is 85 minus 43, or 42% of the primary crusher product. If our problem had covered a crushing condition calling for 80 instead of 85% passing the opening ...
The opening on the open side determines the maximum particle size of the finished product. The closed side not only determines the minimum particle size of the finished product, but also how much material the crusher can accommodate, and how much energy it requires to crush it. Adjusting a Cone Crusher