Dry Separation at Finer Sizes
When a minus 325 mesh fraction is tested, a separation sometimes occurs, but in most cases the feed passes through without separation. Response at higher frequencies was investigated with a smaller ¾ inch cross section U shaped magnet core 1 . Separation was performed with a nonmagnetic nonconducting plane surface 3 moved manually across the magnet pole as illustrated by the direction arrow 4. When separation occurred, the nonmagnetic mineral 5 would move with the plane, and the magn...
See full list on
Application of alternating and intermittent current to magnetic separation at a relatively high number of ampere turns was made possible by special electronic circuits. Actual power losses are low and include the I²R loss, which is the same that occurs in direct current magnetic separation, and the core loss, which has a magnitude corresponding to the I²R loss. Minerals may be dry separated close to the minus 325 mesh size at 60 hertz frequency and possibly at smaller particle sizes at higher frequency. In the wet separation of minus 325 mesh feeds, intermittent current provides for complete release of the magnetic fraction during the discharge cycle. For matted fibrous and magnetically coagulating feeds, a cross belt separator with an intermittent magnetizing current provides efficient separations.
materials and semi ﬁ nished products are called magnetic separation. Kanetec oﬀ ers a wide variety of magnetic separators for use with lump materials, bulk materials, clay like materials and liquids. A magnetic separator to select must be suitable for the purpose of use and have a sufficient capacity.
The MSU LUX mobile separation unit is used to separate ferromagnetic and also non magnetic metal particles. The fundamental bonus is its mobility, maximum separation quality and the dedusting device as a part of this unit.
Magnet separators for the removal of metal are usually installed directly into conveyor pipes. Our pipe magnet and filter magnet systems feature powerful neodymium magnetic rods. When various bulk goods from the plastics and food industries pass over these powerful magnetic rods, the magnetic contaminants in them stick and are removed from the ...
The Cross Belt Separator is a suspended magnet with a continuously running belt that strips off captured tramp metal and discharges off the side or end of the conveyor. The permanent magnetic forces provide continuous and effective removal of unwanted tramp metal. Permanent magnet will retain tramp metal even during power outages and fluctuations.
FILTRATION SYSTEMS Magnetic Separator . The dust particular are attracted and arrested by the magnetic drum. The magnetic drum attracts the dust particles when is goes between body and drum with the help of a scraper dust and allows squeezes by a synthetic rubber roller mounted on the spring drive powder stored into the dust collecting tray.